ADT Security Services BHS-3000C User Manual download pdf (Page 2)

Consumer Information

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

with radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If interference generated by this unit is suspected, call ADT Customer Care at 800.445.0872.

If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient the TV/radio antenna.

• Move the television or receiver away from the unit.

• Plug the unit and the TV/radio receiver into different outlets, i.e., not on the same circuit breaker.

• Contact ADT Security Services or an experienced TV/radio technician for additional suggestions.

This equipment complies with FCC Rules, Part 68.

On the outside of this equipment is a label that contains, among other information, the FCC Registration

Number and Ringer Equivalence Number (REN) for this equipment. If requested, provide this information

to your telephone company.

This equipment is equipped with a USOC RJ31X connector. This equipment is designed to be connected

to the telephone network or premises wiring using a compatible modular jack (RJ31X) that is Part 68

compliant.

The REN is used to determine the quantity of devices you may connect to your telephone line and still have

all devices ring when your number is called. In most but not all areas, the sum of the RENs of all devices

should not exceed five. To be certain of the maximum number of devices you may connect to your line as

determined by the REN, you should call your local telephone company.

Should you experience trouble with the telephone lines, disconnect the equipment from the line to determine

the source of the trouble. If it is determined that the equipment is malfunctioning, discontinue its use

until the malfunction has been corrected. Any repairs or alterations made by the user to this equipment,

or equipment malfunctions, may give the telephone company cause to request the user to disconnect

the equipment. If you experience trouble with this equipment, please contact ADT Customer Care at

800.445.0872 for information on obtaining service or repairs, or visit the Frequently Asked Questions

section of www.MyADT.com.

Should this equipment cause harm to the telephone network, the telephone company may temporarily

discontinue your service. If possible, they will provide you with advance notice. Otherwise they will notify

you as soon as possible. The telephone company will also advise you of changes in its facilities, equipment,

operations or procedures that could affect the operation of your equipment, allowing you the opportunity

to maintain uninterrupted service. You will also be advised of your right to file a complaint with the FCC.

This equipment must not be used on party lines or coin-operated phone lines.

FCC Registration: C2D MUL-35516-AL-E

Ringer Equivalence Number: 0.5B

1 2 3 4 5 6 7 ... 61 62

No comments

ADT Security Services BHS-3000C User Manual Page 2